MAINTENANCE
TROUBLESHOOTING & MAINTENANCE
Most of products have no moving parts. Maintenance is not normally required provided the compressed air filter is used properly.
Large pressure drops are possible across compressed air filter separators if the element is clogged with dirt. Pressure drops are
considered excessive when the lower pressure affects the performance (reduced suction, blowing etc.) in the application.
For replacement or repair filter and regulator parts, contact MIMIKO at +36 30 423 2690 or info@mimiko.hu.
CLEANING
A dirty filter bag can put back pressure on the cleaning products, resulting in reduced suction. The reusable bag should be removed and
shaken over a waste container to remove bulk particulate. The filter bag can be washed in a manner suitable for delicate fabrics.
If contaminants have clogged the cleaning products units, disconnect the compressed air supply and remove all screws to disassemble the
unit. Inspect each part for dirt contamination and a possible oil film on the flow generator. Clean each part and reassemble. The cleaning products units consists of a body, a flow generator, two O-rings and a barbed cap that holds the flow generator in place. The screws that
hold the assembly together are on the intake side of the unit. When reassembling, the small holes of the flow generator should point
to the exhaust end.
Occasionally, there is a buildup which occurs in the throat of the cleaning products units as a result of vapors in the atmosphere. Clean the
surface with a solvent and a clean rag. To prevent contaminants from getting pushed back into the generator holes, perform this
procedure with a small amount of compressed air passing through the cleaning products.
Always clean the vacuum hose and attachments after every use.
If routine cleaning does not solve your performance problems,
please contact an MIMIKO Application Engineer at:
Telephone: +36 30 423 2690
Website: www.mimiko.eu
E-mail: info@mimiko.hu
